Home >

News

02Jun 2023

Chemical Component GB/T5000.6-1998 Of Carbon Steel

Compilation of the chemical composition standards of steel casting parts Table 1 Chemical composition (%) GB919- - -67 Note: I —— advanced cast steel; —— high quality cast steel; —— ordinary cast s...
04Jun 2023

Principle Of Selection Of Radiant Tube Power

Roller table In the above figure, according to the temperature of different furnace section and the furnace, the roller is equipped with the above different roller types to compensate for the diffe...
03Jun 2023

Characteristics Of Tension Rolls

stretch roll Since the high tension is required in the fast cold section, it is necessary to provide the tension roller device at the exit and inlet sections of this section, which is suitable to c...
02Jun 2023

Stove With Steel Tension, Tension Gauge And Tension Rollers

Stove with steel tension, tension gauge and tension rollers Furnace tension The strip passes through the furnace under controlled tension, intended to utilize the self-guidance of the steering roll...
02Jun 2023

Radiant Tube

Radiant tube Type: W type, 200 mm Ø, 8 mm thickness Structure: centrifugal cast heat resistant steel (straight section) and statically cast heat resistant steel (elbow part) Material: pipes 1 and 2...
30May 2023

Rare Earth Wear-resistant BTMCr20 Lining Plate _ Ring _ Side Plate

Rare earth wear-resistant BTMCr20 lining plate _ ring _ side plate Rare earth wear-resistant BTMCr20 lining plate _ ring _ side plate is a manufacturing centrifugal casting, in addition to the mark...
26May 2023

Scope Of Application And Industry Of Bimetal Composite Wear-resistant Pipe

Scope of application and industry of bimetal composite wear-resistant pipe The corrosion resistant materials such as stainless steel, Incoloy625 and Incoloy825 are usually used as the inner layer p...
27May 2023

Thermal Field Characteristics Of Lost Mold Casting

Thermal field characteristics of lost mold casting From the perspective of the forming process of the casting, the solidified casting is the process of liquid metal to the foam type, and it can be ...
26May 2023

The Entry Position Of The Inner Gate in The Lost Mold Casting

The entry position of the inner gate in the lost mold casting The cutting position of the inner gate of disappearing die casting is not whether it can achieve smooth filling and avoid turbulence. S...
24May 2023

Lost Mold Casting Process Runner Design Principles

Lost mold casting process runner design principles In order to prevent the type cavity gas backinjection during pouring, the transverse pouring channel should have enough space to do the gas chambe...
23May 2023

The Gating System Of Lost Mold Casting

The gating system of lost mold casting When analyzing the case, it is found that when the pouring system design is unreasonable, even if the temperature of pouring liquid metal is high enough, the ...
23May 2023

The Lost Foam Casting Process

The lost foam casting process The lost foam casting process can be traced back to April 15,1958, the American scholar H.F. Shruyer It was patented for casting using foam models until the summer of ...

First 7 8 91011 12 13 Last 10/13

News

Chemical Component GB/T5000.6-1998 Of Carbon Steel

Principle Of Selection Of Radiant Tube Power

Characteristics Of Tension Rolls

Stove With Steel Tension, Tension Gauge And Tension Rollers

Radiant Tube

Rare Earth Wear-resistant BTMCr20 Lining Plate _ Ring _ Side Plate

Scope Of Application And Industry Of Bimetal Composite Wear-resistant Pipe

Thermal Field Characteristics Of Lost Mold Casting

The Entry Position Of The Inner Gate in The Lost Mold Casting

Lost Mold Casting Process Runner Design Principles

The Gating System Of Lost Mold Casting

The Lost Foam Casting Process